Welcome to the temperature sensor manufacturers! About us | Contact us | Leaving a message
Service Hotline

Product list

You only need a phone we will provide the most suitable products, let you spend the least money, to achieve the best results

Service Hotline

Related information

Service Hotline:




Add:Changping Town, Dongguan bridge Lek industrial zone 15

Current position:Home > Products > Automotive Sensors >

Dual Output Oil Pressure Temperature Sensor

  • Service Hotline:13827205356
  • Details

  • Contact us

Product Introduction


Adjustable range, up to 1.5MPa
ECU engine oil pressure for the linear voltage output, oil temperature for the resistance output
Instrument output PWM signal, and with the alarm signal output, alternative mechanical sensors to match a variety of dynamic table and stepper motor instrument
Threaded mouth can be customized with customer requirements

When the engine oil pressure temperature sensor fails, there will be two cases:
The engine control unit records the fault code or the engine control unit maintains the engine emergency operation with a substitute value.Thus, for the detection of new sensors,Need to analyze the signal waveform to determine whether the sensor failure, and then repair or replacement.Intelligent, miniaturized new sensor, For automotive testing to provide more high-quality data, Effectively enhance the collection of information data efficiency,Real-time monitoring of the vehicle control system, Effectively improve the efficiency of vehicle fault diagnosis, For the safety and efficiency of vehicle operation to provide protection.

The pressure signal is used for the linear control of the characteristics of the oil pump. The temperature signal is used for the engine heat management system.This sensor is installed in the main engine oil path and is subject to the oil pressure and oil temperature there.So no need to measure the oil temperature in the oil pan, but directly measure the actual engine oil temperature.

The engine oil pressure temperature sensor measures the absolute pressure of the engine oil and its temperature.The measured value is output as a pulse width modulated signal.The measurement method is based on a micro-mechanical piezoresistive pressure sensor (silicon), It provides an output signal proportional to the pressure, The temperature measurement is achieved by a diode. The internal structure of the sensor is shown in Figure 4, The pin arrangement is as follows, 5V: 5V supply voltage; PWM: engine oil pressure temperature sensor pulse width modulation signal; KI.31 E: Bus terminal KI. 31, Pressure and temperature sensor ground wire.

Engine oil pressure The temperature sensor is connected via a three-pin plug,As shown in Figure 5, the engine oil pressure temperature sensor is grounded from the engine control unit and a 5V supply voltage.The pulse width modulation signal is divided into three fixed periods.
The first cycle is used for synchronization and diagnostic signals.
The second cycle passes the temperature signal,
The third cycle passes the pressure signal.
Oil Pressure Temperature Senso

Order:Dual Output Oil Pressure Temperature Sensor

Coffee Packaging Machine ksd301 thermostat Blow Molding Machine Emergency Lighting Battery Sublimation Inks China Wifi Modules